Wi-Fi Access Point Installation in San Francisco CA – #1 C7 Licensed Contractor

Wi-Fi Access Point Installation in San Francisco CA

We mount, connect and configure commercial Wi-Fi access points on ceilings, walls and outdoor structures, placed where a survey shows they’ll do the most good, then verify coverage before we leave.

Need Wi-Fi access point installation in San Francisco CA? Whether you’re adding a few APs to fix dead zones, upgrading a whole floor to Wi-Fi 6E or Wi-Fi 7, or putting coverage on a patio or loading dock, our C-7 licensed technicians handle the mounting, the PoE connection and the setup in one visit. We check that every AP has the cable and switch power it needs, so new hardware performs the way it should.

Adding, replacing or upgrading access points? Get a site walk and itemized quote. Call (628) 215-7235.

Request a quote

AP Installation Services

From a single AP in a back office to hundreds across a campus, these are the jobs we handle most.

  • New AP installs

    Ceiling and wall APs placed from a site survey and design, mounted, connected to PoE and configured for your network.

    • Ceiling Mounts
    • Wall Mounts
    • PoE Hookup
    • Configuration
  • Wi-Fi 6E and Wi-Fi 7 upgrades

    Swapping older Wi-Fi 5 and Wi-Fi 6 APs for new models, including checks that your cable and switches can deliver the speed and power they need.

    • AP Replacement
    • Uplink Checks
    • PoE Budget
    • Firmware
  • Dead zone fixes

    Adding or relocating access points where signal drops out: back offices, conference rooms, stairwells and the far ends of long floors.

    • Coverage Gaps
    • AP Relocation
    • Added APs
    • Heat Mapping
  • Outdoor APs

    Weather-rated APs on walls, poles and rooftops for patios, courtyards, loading docks and parking areas.

    • IP67 Housings
    • Patios
    • Loading Docks
    • Pole Mounts

Where Each AP Should Go

An access point’s location matters more than its brand. APs work best mounted on the ceiling, facing down, near the middle of the area they serve and clear of metal obstructions like ductwork, beams and light fixtures. In a typical office, that works out to roughly one AP for every 1,500 to 2,500 square feet, with more in conference rooms and other spots where people gather.

Spacing also has to leave some overlap between neighboring APs so laptops and phones can roam from one to the next without dropping a call. We design for a signal of -67 dBm or stronger in every work area, the common target for voice and video, and set transmit power and channels so APs help each other instead of competing.

Access point mounting options and typical power needs
Mounting typeWhere it’s usedHow we install it
Drop ceiling (T-bar)Most offices and clinicsRail clip or tile bracket, cable above the tile, AP centered on the tile
Hard lid ceilingDrywall and plaster ceilings, lobbiesFlush or surface mount with cable fished through an access hole
Open ceilingWarehouse conversions, retail, restaurantsBeam clamp, drop rod or conduit box at a set height
Wall mountHotel rooms, classrooms, hallwaysWall-plate AP or bracket over a recessed box
OutdoorPatios, courtyards, docks, parkingWeather-rated AP on wall, pole or roof mount with sealed cable entry
Typical access point power draw and the PoE standard each needs
AP typeTypical power drawPoE standardUplink
Wi-Fi 6 (2×2 or 4×4)About 15–25 W802.3at (PoE+, 30 W)1–2.5 Gbps
Wi-Fi 6E (tri-band)About 20–35 W802.3at or 802.3bt2.5–5 Gbps
Wi-Fi 7 (tri-band)About 30–50 W802.3bt (PoE++, up to 60–90 W)5–10 Gbps
Outdoor APAbout 20–40 W802.3at or 802.3bt1–5 Gbps
Tri-band Wi-Fi 6E ceiling access point for commercial installation
A tri-band Wi-Fi 6E AP mounted on a T-bar rail clip at 9 ft, fed by one Cat6A drop delivering 802.3bt power and a 5 Gbps uplink. Neighboring APs sit about 45 ft apart for overlap and smooth roaming.

Places we install APs

  • Open offices
  • Conference rooms
  • Lobbies and reception
  • Hotel guest floors
  • Retail sales floors
  • Restaurants and patios
  • Warehouse aisles
  • Classrooms
  • Exam rooms and clinics

AP Projects Across the City

Financial District weekend upgrades

Replacing a full floor of Wi-Fi 5 APs with Wi-Fi 6E over a weekend in a Montgomery Street tower, so staff came back Monday to faster Wi-Fi and no downtime.

North Beach historic buildings

Hard lid and plaster ceilings in older Columbus Avenue buildings, where APs are surface-mounted and cable is fished carefully to protect original finishes.

Hayes Valley restaurant patios

Outdoor APs on walls and awnings so guests and handheld point-of-sale devices stay connected from the dining room to the back patio.

Dogpatch warehouse aisles

High-mounted APs on beam clamps above racking, aimed down each aisle so scanners and tablets hold signal between steel shelves.

How We Install and Connect Each AP to Your Network

  1. Survey and placement

    We check existing coverage, ceilings and obstructions, then mark each AP location on your floor plan.

  2. Cable and power check

    We confirm every location has a certified Cat6A drop and that your PoE switches have enough power budget for the new APs.

  3. Pre-staging

    APs are updated, labeled and loaded with your SSIDs, VLANs, WPA3 security and roaming settings before they go up.

  4. Mounting and connection

    Each AP is mounted with the right bracket, connected and brought online, one area at a time to keep your network running.

  5. Validation

    A walk-through survey confirms signal strength and roaming, and you receive heat maps and an AP location map.

Access points depend on good design and good cable. See our main wireless networks page for the full overview, or explore these related services.

AP Installation Service Area

We install access points in every neighborhood of the city, plus these Peninsula, East Bay and Marin cities:

See every location on our service area page.

Request an AP Installation Quote

Tell us how many APs you need, the model if you’ve already chosen one, and the areas you want covered, and we’ll return an itemized quote, usually within two business days.

San Francisco Telecom Techs
One Beach St, San Francisco, CA 94133
Phone: (628) 215-7235
Email: [email protected]

Get access points that are placed right, powered right and proven to cover.

Request a quote

Send us your project details